FUTABA T18SZ - Page 12

Theoutputvariomelodydoesnotchangeduringthe
delaytime.Inotherwords,thisisaminimumtimeof
Variomelodyoutput.
Settingrange：0.0s，0.5s，1.0s，1.5s
Initialvalue：0.0s
*This parameter is effective to all variometers.
2.Telemetry Alarm Duration and Repeat time
The repeat time and duration time for the telemetry alarm (buzzer, vibration and speech) can be set.
3.French speech localization
French localization of telemetry speech function is available. If you would like to use the French speech
function, update software of your T18SZ to the French version of the new software.
Durationisnotdisplayedwhen
RepeatisINH.
Delay
ActuallyVariometer
0.0m/s
1.0m/s 3.0m/s 4.0m/s -1.0m/s2.0m/s
OutputVarioMelody
Delaytime
1.0s
0.0m/s 1.0m/s 3.0m/s 4.0m/s -1.0m/s2.0m/s
žŹƄƕƌƒŃŰƈƏƒƇƜŃŧƈƏƄƜƀ
Alarm
output
Durationtime5s
Repeattime8s
OFF OFF OFF
ON ON ON
e.g.Repeattimeis8secondsandDurationtimeis5seconds.
žŧƘƕƄƗƌƒƑŃƄƑƇŃŵƈƓƈƄƗŃƗƌƐƈŃƉƒƕŃŷƈƏƈƐƈƗƕƜŃŤƏƄƕƐƀ
Tap the [Telemetry Setting] button in the Linkage menu to call the setup screen shown below.
Duration
Itisanalarmoutputtime.
Settingrange：1s 〜30s
Initialvalue：INH
Durationvaluehastobelessthan
repeatvalue.
Durationtimeisextendedwhenthe
otheralarmeventoccurs.
Repeat
Itisarepeattimeofanalarm
output.
Settingrange：INH，1s 〜240s
Initialvalue：INH
4.Stick mode
Mode 3 and 4 have been added.