FUTABA T3PK

40
Functions
(Initial screen)
MENU
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the button.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
Throttle EXP/TH-EXP (Throttle system)
This function makes throttle trigger high side and brake side direction servo opera-
tion quicker or milder. It has no effect on the servo maximum operation amount.
For the high side, selection from among three kinds of curves (EXP/VTR/CRV) is
also possible.
Advice
When the course conditions are good and there is no sense of torque at the power unit,
set each curve to the + side (quick side). When the road surface is slippery and the
drive wheels do not grip it, set each curve to the - minus (mild) side.
Curve selection
First, select the type of forward side
curve at the "FWD-TYP" item. The
setup item (screen) varies with the
type of curve. The figure at the bottom
left is the EXP curve setup screen.
Setup items
RATE : Forward side rate
FWD-TYP : Forward side curve selection
BRK-EXP : Brake side rate
Adjustment range
RATE : -100 ~ 0 ~ +100%
FWD-TYP : EXP, VTR, CRV
BRK-EXP : -100 ~ 0 ~ +100%
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Adjustment method for EXP curve
(Preparation)
- Select "EXP" at setup item "FWD-TYP".
- Select setup item "RATE" and make the following ad-
justments:
1 Forward side adjustment
Use the (+) button to adjust the + side when you
want to quicken the rise and use the (-) button to
adjust the - side when you want to make the rise
milder.
2 Brake side adjustment
Select "BRK-EXP" by pressing the (DN) button
twice, and use the (+) button to adjust the + side
Setup item switching
0 Use the (DN) or (UP) button to
switch the setup item.