Warning
Receiver Vibration-proofing / Waterproofing
(Car)
Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material and mount it
with thick double-sided tape.
When using the receiver holder supplied with the model kit, mount the holder to the chassis through a rub-
ber grommet.
(Boat)
Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material. Also water-
proof the receiver by cruising it in a plastic bag.
If the receiver is exposed to strong vibration and shock, or the ingression of water, it may not operate correctly and you may lose con-
trol of the model.
Connector Connections
Be sure the receiver, servo, battery and connectors are fully and firmly connected.
If vibration from the model causes a connector to work loose while the model is in operation, you may lose control.
Servo Installation
When you install the servos, always use the rubber grommets provided in servo hardware bags. Mount the
servos so they do not directly come in contact with the mount.
If the servo case comes in direct contact with the mount, vibration will be directly transmitted to the servo.
If this condition continues for a long time, the servo may be damaged and control will be lost.
Screw
Mechanical plate
Nut (as required)
Eyelet
Damper
(or)
:KHQLQVWDOOLQJWKHVHUYRDOZD\VLQVWDOOWKHDFFHVVRU\
UXEEHUJURPPHWDQGJURPPHWÀXVKDJDLQVWWKHVHUYR
$YLEUDWLRQGDPSLQJHIIHFWLVQRWREWDLQHGLIWKH
rubber grommet and grommet are not installed
correctly.
Screw
Mechanical plate
Nut (as required)
Receiver holder
Damper
:KHQXVLQJWKHUHFHLYHUKROGHUVXSSOLHG
ZLWK WKH NLW LQVWDOO WKH UHFHLYHU WKURXJK D
rubber grommet.
Foam rubber, etc.
:UDSWKHUHFHLYHULQIRDPUXEEHURURWKHUYLEUDWLRQ
absorbing material. Do not use hard material. Hard
PDWHULDOGRHVQRWKDYHDYLEUDWLRQSURR¿QJHIIHFW
Mechanical plate
Thick double-sid-
ed tape
:KHQ PRXQWLQJ WKH UHFHLYHU ZLWK GRXEOHVLGHG WDSH
do not use a stiff tape. Stiff tape does not have a vibra-
WLRQSURR¿QJHIIHFW
27
Installation
To Next Page
Loading...
