Warning
Servo Throw
Operate each servo over its full stroke and be sure the linkage does not bind or come loose.
The continuous application of unreasonable force to a servo may cause damage and excessive battery drain.
Warning
Electronic Speed Control
Install the heat sinks where they will not come in contact with aluminum, carbon fiber or other parts that con-
duct electricity.
If the ESC (Electronic speed control) heat sinks touch other materials that conduct electricity a short circuit could occur. This could re-
sult in loss of control and damage to the system.
Motor Noise Suppression
Always install capacitors to suppress noise when electric motors are used.
If capacitors are not properly installed you could experience erratic operation and reduced range as well as loss of control.
$GMXVWWKHWKURWWOH VHUYR VRWKDWXQUHDVRQDEOH IRUFH LV
QRWDSSOLHGZKHQWKHHQJLQHFDUEXUHWRULVIXOO\RSHQ
IXOO\FORVHGDQGWKHEUDNHVDUHDSSOLHGIXOO\
,IWKHEUDNHVRYHUKHDWZKLOHUXQQLQJWKHLUDELOLW\WR
IXQFWLRQSURSHUO\GHFUHDVHV%HIRUHUXQQLQJDGMXVWWKH
suitable maximum servo travel so that unreasonable
IRUFHLVQRWDSSOLHGHYHQZKHQWKHVHUYRWUDYHO LVLQ-
FUHDVHGZKLOHUXQQLQJ
$GMXVWWKHVWHHULQJ VHUYR VRWKDWXQUHDVRQ-
able force is not applied to the servo by the
chassis at maximum servo travel.
Decide the EPA value at
the contact point.
Caution!
A whining noise indicates that the
steering servo is improperly set.
Other Noise Suppression Methods
Be sure there are no metal parts in your model which under vibration can come in contact with other metal
parts.
Metal to metal contacts under vibration will emit a high frequency noise that will affect the receiver’s performance. You could experi-
ence erratic operation and reduced range as well as loss of control.
0RWRUVZLWKQRVXSSUHVVRUFDSDFLWRUVRULQDGHTXDWH
VXSSUHVVLRQPD\FDXVH WKHUHFHLYHUWRPDOIXQFWLRQ
$OZD\VVROGHUWKHFDSDFLWRUVVXSSOLHGWR\RXUPRWRU
The Schottky diode improves the efficiency of the
speed control / motor combination and provides ex-
WUDSURWHFWLRQWRWKHEUDNH)(7V7KHZKLWHULQJPXVW
DOZD\VIDFHWKHSRVLWLYHVLGH
Schottky diode
"-" side
"+" side
123
28
Installation