FUTABA T4PM

page 2page 1
When the connected servo
type is not compatible with
the SR mode, "----" is dis-
played.
The servo ID
Displays the ID of the servo
whose parameters are to be
read.
Servo model name
Setup item selection
Select by the (JOG) button.
The item indicated by the reverse dis-
played cursor is selected.
79
Function
Display data list
1
The type and data of the loaded servo are displayed. Since there are page two setting
items, change the page as follows.
S.BUS Link Function "S.BUS SX"
 'R QRW SOXJ LQ RU GLVFRQQHFW VHUYRVRUFRQQHFW RWKHU VHUYRVZKLOH NHHSLQJ WKH
VFUHHQZKHUHGDWDZDVUHDGE\
"
5($'
"
%HVXUHWRFRQQHFWWKHVHUYRLQWKHVWDWH
ZKHUH
"
:5,7(
"
or
"
RESET
"
LV¿QLVKHGRUSUHVVWKH+20(EXWWRQWRDFFHVVWKH
accessory menu screen.
7KHORDGHGGDWDFDQQRWEHZULWWHQWRDQRWKHUVHUYR
· Since the change function of SR and normal takes precedence over other parameter settings,
this setting is done fi rst. Also, when SR mode is changed, it is initialized to that mode.Load
the servo referring to page 78.
SR mode setting (Wired only)
1
Select the setting item "SR-M" on page 2 by moving the(JOG)
button left, right, up or down, and select the NORM, SR1, SR2,
or SR3 with (+) or (-) button.
-There is one type of servo for SR-1 selection of SR mode.
:KHQVHUYRLVVHWWR65PRGH6565RU65FDQEHFKDQJHGE\ZLUHOHVVVHW
ting.
2
(Writing to S.BUS/S.BUS2)
Since "CHANGE?" Is displayed at the bottom of the screen,
press the (JOG) button.
$IWHU:$,7LVGLVSOD\HGWKH&203/(7(EOLQNVRQWKHVFUHHQDQGWKHVHWWLQJ
GDWDLVZULWWHQWRWKHVHUYR
,I&20(5525EOLQNVRQWKHVFUHHQFRPPXQLFDWLRQZLWKWKHVHUYRLVQRWEHLQJ
performed normally. Check the T4PM and servo connection and the battery connec-
WLRQWRVHUYRDQGUHSHDWZULWLQJ
Caution
Do not connect any servos that are on SR mode to a receiver via
S.BUS/S.BUS2 terminal. You cannot use an SR servo in the SBUS/
S.BUS2 ports, as they are not compatible with SR mode.
The SR servo can be damaged if it is connected into the S.BUS/S.BUS2 ports.