Futurecom P25 - DVRS Profile Settings Programmable in the APX MSU

8M083X25 R14
APX Series P25 Interface
DVRS Installation & Programming Guide – PART II
January 2019
Page 58 of 153
DVRS Profile Settings Programmable in the APX MSU
The following features are programmed in the corresponding DVRS Profiles in the APX
MSU:
MSU Field Name
Options/Units
Description
Notes
DVRS Profile
Name
Name
Desired Profile
Name
DVRS Remote
Activation
‘Disabled’
‘Via Call Alert’
‘Disabled’: Call
Alerts from the FNE
addressed to the
MSU's Radio ID are
handled in the
same way that a
regular Call Alert is
handled.
‘Via Call Alert’: Call
Alerts from the FNE
addressed to the
MSU's Radio ID
cause the DVR to
cycle through it’s
Modes: System,
Local and Off.
When this feature is
Enabled, the MSU
can no longer
initiate or receive a
regular Call Alert.
Generate Status on
DVRS Mode
Change
Enable / Disable
Check Box
Enables / Disables
the MSU sending
Status message to
the FNE to indicate
the current DVRS
mode after EVERY
DVR mode change
regardless of the
trigger (CH button
or remote change
by PSU or by FNE).
The MSU sends the
following Status
updates when this
feature is Enabled:
Status 1 = OFF
Status 2 = LOCAL
Status 3 =
SYSTEM
ICM Allowed
Enable / Disable
Check Box
Enables / Disables
the In Car Monitor
Functionality for a
given DVR
Personality
Refer to the Global
DVRS Features
Section of this
document for
details on ICM
operation.