12
4. Additional Functions
4.1 One-Time Irrigation
This function is used to program the irrigation
controller to operate the irrigation system
once only, for the set irrigation duration, at
the set time.
(Duration set as described in Section 3.4).
1.Press until appears.
2.Press several times (for all the days
of the week) until
appears, and
blinks on the display.
3.Go to Section 4.3 to set the day and time.
4.2 Cyclical Irrigation
This option is used to program the irrigation
controller to operate the irrigation system in
a cyclical manner, once every x days, for the
irrigation duration.
(Note: Duration for which valve stays open
set as described in Section 3.4).
1. Press until appears.
2. Press
several times (for all the days
of the week) until
appears, and
blinks on the display.
3. With the display blinking, press
or . The interval between irrigation sessions
(irrigation cycle) in days, hours or minutes is displayed. For example, if you set 2
days, the irrigation will be performed every two days for the defined duration.
To Next Page
Loading...
Need help?
General
