5.2 Blinking Low Battery Warning
When the batteries are low, a blinking battery
icon appears on the display. In this state, the
batteries still enable valve operation, but must
be promtly replaced.
After replacing the batteries, press any button
to resume irrigation controller operation.
Programmed data are retained if batteries
are replaced within 30 seconds.
16
5. Additional Displays
5.1 Valve in Wait Mode
This section does not apply to the
DC-1 Model.
When two valves are currently open, and
a third valve is scheduled to open, the third
valve enters into wait mode. A blinking
appears above the number of the waiting
valve. When one of the first two valves
closes, the waiting valve opens. During
"manual" operation of a waiting valve via
the irrigation controller, the letter "W" (Wait)
appears on the display. The valve opens
when another valve closes.
To Next Page
Loading...
Need help?
General
