G.S.I DC Installation and Operation Guide
13
Connecting the Solenoids to the Controller
(Outputs)
To connect the solenoids to the controller:
1. Insert the solenoid wires through the cable gland at the bottom of
the controller.
2. Connect the wires to the corresponding connectors according to
wire color, that is, connect the black wire to the connector labeled
B, and the red wire to the connector labeled R.
3. Connect the wires coming from the Master valve to the connector
marked M.
4. To connect a fertilizer, always connect the wires from the fertilizer
to the connector marked 12.
Figure 17: Output Connectors Labeled B and R
Note: It is highly recommended that you label the output
wires, by function, for future reference.
To Next Page
Loading...
