SmartScale 300 User Manual
Page 21
Deleting a weight from the statistics
In the Automatic weighing mode, statistics are updated each time the
Scale captures a weight. In the Manual or Fine modes, a weight is
captured and the statistics updated only if the operator presses the
green button.
You can delete a captured weight from the statistics at two stages
during a weighing session ;
while the animal or static load is still supported by the platform; or
immediately after the animal has stepped off the platform or the
static load has been removed from the platform.
If you delete a weight from the statistics while the animal or static
load is still supported by the platform, you can also re-weigh by
pressing the green weigh button.
To Next Page
Loading...
