User Manual SmartScale 300
Page 28
Weighing static loads - fine mode
1. Turn the mode select switch to F (Fine mode).
2. If you want to reset the statistics display to zero, press the
button.
For more information refer to Clearing the statistics (p 24).
3. Check that the weight displayed is zero. If it is not, check that no
unwanted objects are resting on the weighing platform, then press
the blue zero button.
Note:
The
icon does not display in Fine mode.
4. Place the load onto the platform.
5. Record the weight.
6. Press the green weigh button if you want to add the weight to the
statistics.
7. If the weight has locked on, but you want to re-weigh the load,
press the green Weigh button. The Scale re-weighs the load and
locks the weight again. The new weight replaces the original
weight and the statistics are updated.
To Next Page
Loading...
