Console module »DVI-CON-Fiber«
Computer and console modules · 129
Installation
Connecting the console devices
Keyb.: Connect the PS/2 keyboard of the local console.
Mouse: Connect the PS/2 mouse of the local console.
Keyb./Mouse: Connect the USB keyboard and/or USB mouse of the local console.
Generic: By default (Keyb./Mouse mode), you can use this interface to connect another
USB input device or supported displays or tablets.
Enable the Generic HID mode (see page 193 f.) if you want to connect another USB
input device. In this mode, data of the USB input device remains unaltered when
transmitted to the active computer module.
DVI/VGA Out: Connect the monitor of the local console.
Micro In: Connect the microphone of the local console (optional).
Speaker: Connect the speakers of the local console (optional).
LED Out: If you purchased and added the TradeSwitch feature to the matrix switch, con-
nect the optional TS-LED here.
NOTE:
Both keyboard and mouse signals can be transmitted to the computer using
the PS/2 or the USB interfaces.
NOTE:
You can also use PS/2 and USB devices, for example by connecting a USB
mouse and a PS/2 keyboard.
IMPORTANT:
With enabled Generic HID mode, it is not possible to operate the OSD
with a keyboard connected to the
Generic socket.
Transmission
Main Power
Red. Power
DVI / VGA Out
LED out
Mouse
Keyb.
Micro In
Keyb./Mouse
Speaker
Generic
Transmission
a
n
ower
.
w
To Next Page
Loading...
Need help?
General
