IDL 101
INITIATION AND TEST
58
HB_IDL101_E_V222.doc
Gantner Instruments Test & Measurement GmbH
9. INITIATION AND TEST
9.1. Before Connecting the Supply
Before connecting the distribution voltage with the data logger, once again check the device as to its appropriate
installation and as to its correct voltage control. Please make absolutely sure that the data loggers have been connected
to ground as prescribed and the distribution voltage for all data loggers does not exceed the indicated 30 VDC.
9.2. After Connecting the Supply
After connecting the distribution voltage the data logger displays the current operating state on the two LEDs at the
front of the device (in case the LED display is not switched off). The meanings of the LEDs are given in table 9.1. on the
following page.
9.3. Configuration of the Data Logger
Before entering into operation the data logger has to be programmed and configured as to its specific application. In
most cases the programming has already been carried out on delivery (see status of RUN-LED and ERR-LED, table 9.1).
The configuration has to be carried out by the user by means of the
Configuration Software ICP 100
on a PC.
RUN
(green LED)
ERR
(red LED)
meaning
off The distribution volta
e has been selected too low or the power supply cannot
supply the required power.
off flash The data logger is in the monitor mode. A valid program has not yet been
loaded; the appliance is not yet operable.
on There is a sensor error detected by the module. Possible causes may be: 1.
wron
uration, 2. line break or short circuit, 3. measured value too lar
e
or too small.
off The data transmission between the data lo
er and the PC is active. There is
no error at the moment.
flash flash The data lo
er is in the download mode. Currently a pro
ram or a
configuration is transmitted to the module.
on There is a sensor error detected by the module. Currently data transmission
between the module and the PC is active.
off The distribution volta
e has been connected orderly. There is no error. Data
transmission to the module via bus is not active.
on flash There is a communication error detected by the module (bus timeout).
Possible causes may be: 1. PC/SPS-program stopped, 2. bus line break.
on There is a sensor error detected by the module. Possible causes may be: 1.
wrong configuration, 2. line break or short circuit, 3. measured value too lar
e
or too small.
short off X
ust been dispatched from the data lo
er via bus to a control
system or to a PC.
Table 9.1 Meanings of the LEDs (flash frequency approx. 1Hz)
To Next Page
Loading...