Gardner Denver VS80A - Page 79

13
-
18
-
610 Page
78
14-3
Maintenance Schedule
As
indicated by Controller
Every 8 hours of operation
Every 125 hours of operation
Per oil analysis results
3 months/1000hours
6 months/2000 hours
9 months/3000 hours
12 months/4000hours
15 months/5000hours
18 months/6000hours
21 months/7000hours
24 months/80
00hours
27 months/9000hours
30 months/10000hours
33 months/11000hours
36 months/12000hours
39 months/13000hours
42 months/14000 hours
45 months/15000 hours
48 months/16000hours
51 months/17000hours
54 months/18000hours
57 months/19000hours
60
months/20000hours
Check air/oil reservoir oil level x
Check operation of the machine, is it loading and unloading properly x
Check discharge pressure and temperature x
Check control panel for advisory text messages x
Inspect, Clean if necessary Cooler / Fan
x
Replace oil filter element
x
x x x x x x x x x x x x x x x x x x x x
Replace Control Box Filter (if applicable)
x x x x x x x x x x x x x x x x x x x x
Replace package enclosure filter pad (if applicable)
x x x x x x x x x x
Replace air filter element
x
x x x x x x x x x x
Oil Sample
x x x x x x x x x x
Replace Air/Oil Separator
x
x x x x x
Inspect, clean if necessary scavenge line, replace check valve
x x x x x
Inspect, service if necessary Inlet Valve
x x x x x
Visually check for leakage Shaft Seal
x x x x x
Inspect, re-grease if necessary Motor Bearings
x x x x x x
Inspect, Replace if necessary Drive Belts (if applicable)
x x x x x
Replace Lubricant
x x
x x x x x
Check pressure relief valve
x x x x x
Inspect, replace if necessary Solenoid Valves / Vacuum Switch
x x
Inspect, replace if necessary Blow-down Valve
x x
Inspect, replace if necessary Thermistor Probes
x x
Inspect, replace if necessary Pressure Transducer
x x
Inspect, replace if necessary Min. Pressure/Check Valve
x x
Inspect, replace if necessary Thermal Mixing Valve
x x
Inspect, replace if necessary the drive Coupling Spider
x x
Inspect, replace if necessary Hoses
x x
Inspect, repair if necessary Turn valve
x x