13-18-610 Page 79
Maintenance Schedule
As indicated by Controller
Every 8 hours of operation
Every 125 hours of operation
months/25000hours
Check air/oil reservoir oil level x
Check operation of the machine, is it loading and unloading properly x
Check discharge pressure and temperature x
Check control panel for advisory text messages x
Inspect, Clean if necessary Cooler / Fan
x
Replace oil filter element
x x x x x x x x x x x x x x x x x x x x
Control Box Filter (if applicable)
x x x x x x x x x x x x x x x x x x x x
Replace cool air inlet filter pad (if applicable)
x x x x x x x x x x
Replace air filter element
x x x x x x x x x x
Oil Sample
x x x x x x x x x x
Replace Air/Oil Separator
x x x x x
Inspect, clean if necessary scavenge line, replace check valve
x x x x x
Inspect, service if necessary Inlet Valve
x x x x x
Visually check for leakage Shaft Seal
x x x x x
Inspect, re-grease if necessary Motor Bearings
x x x x x x x
Inspect, Replace if necessary Drive Belts (if applicable)
x x x x x
Replace Lubricant
x
x
x x x x x
Check pressure relief valve
x x x x x
Inspect, replace if necessary Solenoid Valves / Vacuum Switch
x x x
Inspect, replace if necessary Blow-down Valve
x x x
Inspect, replace if necessary Thermistor Probes
x x x
Inspect, replace if necessary Pressure Transducer
x x x
Inspect, replace if necessary Min. Pressure/Check Valve
x x x
Inspect, replace if necessary Thermal Mixing Valve
x x x
Inspect, replace if necessary the drive Coupling Spider
x x x
Inspect, replace if necessary Hoses
x x x
Inspect, repair if necessary Turn valve
x x x