Garmin G2000 Cockpit Reference Guide for the Cessna Corvalis T240
190-01264-01 Rev. A 127
Annunciations & Alerts
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS FMS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
System Message Comments
GPS1 SERVICE
– GPS1 needs
service. Return unit for repair.
A failure has been detected in the GPS1 and/or GPS2
receiver. The receiver may still be available. The system
should be serviced.
GPS2 SERVICE
– GPS2 needs
service. Return unit for repair.
GPS1 FAIL
– GPS1 is
inoperative.
A failure has been detected in GPS receiver #1 and/or
GPS receiver #2. The system should be serviced.
GPS2 FAIL
– GPS2 is
inoperative.
NAV1 SERVICE
– NAV1 needs
service. Return unit for repair.
A failure has been detected in the NAV1 and/or NAV2
receiver. The receiver may still be available. The system
should be serviced.
NAV2 SERVICE
– NAV2 needs
service. Return unit for repair.
NAV1 RMT XFR
– NAV1
remote transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck
in the enabled (or “pressed”) state. Press the transfer
switch again to cycle its operation. If the problem
persists, the system should be serviced.
NAV2 RMT XFR
– NAV2
remote transfer key is stuck.
G/S1 FAIL
– G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/
or receiver 2. The system should be serviced.
G/S2 FAIL
– G/S2 is inoperative.
G/S1 SERVICE
– G/S1 needs
service. Return unit for repair.
A failure has been detected in glideslope receiver 1 and/
or receiver 2. The receiver may still be available. The
system should be serviced when possible.
G/S2 SERVICE
– G/S2 needs
service. Return unit for repair.
NAV1 MANIFEST
– NAV1
software mismatch,
communication halted.
The NAV 1 and/or NAV 2 has incorrect software
installed. The system should be serviced.
NAV2 MANIFEST
– NAV2
software mismatch,
communication halted.
To Next Page
Loading...
Need help?
General
