Garmin G2000 Cockpit Reference Guide for the Cessna Corvalis T240
190-01264-01 Rev. A 71
Hazard Avoidance
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS FMS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
Selecting ‘Cell’ or ‘Strike’ as the Stormscope Operating Mode:
NOTE: “Cell mode” uses a clustering program to identify clusters of electrical
activity that indicate cells.
1)
From the Home Screen, touch Weather > Weather Selection >
Stormscope Settings.
2)
Touch the Cell or Strike Button to select the desired operating mode. A
green annunciator indicates the active operating mode.
Or
:
1)
From the Home Screen on the Touchscreen Controller, touch Map > Map
Settings.
2)
Touch the Sensor Tab.
3)
If necessary, scroll to display the Stormscope Lightning Button.
4)
Touch the Settings Button.
5)
Touch the Cell or Strike Button to select the desired operating mode. A
green annunciator indicates the active operating mode.
Clear Stormscope Data from the Display
1)
From the Home Screen, touch Weather > Weather Selection >
Stormscope Settings.
2)
Touch the Clear Stormscope Lightning Button to remove lightning
indications on the display.
Or
:
1)
From the Home Screen, touch Map > Map Settings.
2)
Touch the Sensor Tab.
3)
If necessary, scroll to display the Stormscope Lightning Button.
4)
Touch the Settings Button.
5)
Touch the Clear Stormscope Lightning Button to remove lightning
indications on the display.
To Next Page
Loading...
Need help?
General
