Garmin GPSMAP 3205 - Nav (Navigation) Alarms; Sonar Alarms; Weather Alarms

GPSMAP 3205 Owner’s Manual 57
MaIn Menu > alarMs tab
Nav (Navigation) Alarms
Use the Nav sub tab to set navigational alarms including anchor drag, arrival, and off course.
The Nav sub tab contains the following alarms:
•
Anchor Drag—sets an alarm to sound when a specied drift distance is
exceeded. Enter a value in the distance eld, and use the control eld to
turn the alarm on and off.
•
Arrival—sets an alarm to sound when a specied distance or time away
from a destination waypoint is exceeded. Enter a distance, radius, or time
for sounding the alarm, and use the control eld to set the alarm to Off,
Dist (distance), or Time.
•
Off Course—sets an alarm to sound when you are off course by a specic
distance. Enter a distance in the distance eld, and use the control eld to
turn the alarm on and off.
Sonar Alarms
Use the Sonar sub tab to set sonar alarms including shallow or deep water,
water temperature, and sh.*
The Sonar sub tab contains the following alarms:
•
Shallow Water/Deep Water—sets an alarm to sound when you enter
an area of specied depth that is too shallow or too deep. You must be
receiving sonar data for this function to work.
•
Water Temperature—sets an alarm to sound when the transducer reports
a temperature either above, below, inside, or outside the specied values.
•
Fish —sets an alarm to sound when the unit detects a sh of the specied
symbols.
*You must be receiving NMEA sonar data or using a GSD 21 or GSD 22 for the sonar alarms
to function.
Weather Alarms
Use the Weather sub tab to set weather alarms, including marine, tornado, severe
storm, ood, and ash ood warnings.**
**You must have a GDL 30/30A Satellite Weather Receiver connected to your
GPSMAP 3205 for weather alarms to function.