Page 3
709-BTP3 Manual
T
he SEELEVEL II
TM
Tank Monitor represents a massive leap
forward in level measurement technology for the Recreational
Vehicle industry. The SeeLeveL has a combination of features,
accuracy, reliability, and diagnostic capability that have never been
available before.
Model 709-BTP3 will monitor the battery voltage, the fresh water
and sewer holding tanks, the LPG tank and includes a pump switch.
The 709-BTP3 has Bluetooth
®
wireless technology capability so that
tank levels and battery voltage can be shown on a smartphone or
tablet with the free downloaded app.
Tank information is also displayed on your 3-digit alpha-numeric
LED display. There is one alarm output available which can be
used to signal a high or low water or sewer level as required. In
addition, the system can display the operating characteristics of
each of the tank sending units, giving it unsurpassed diagnostic
capability.
CHAPTER 1 - OVERVIEW
WARNING: All power circuits must be fused. If a fuse
is not provided with the system then it is the installer’s
responsibility to install a fuse with a maximum rating of 7.5
amps. A relay is required if more than 7.5 amps is needed for
the pump.
For more detailed information please refer to Chapter 7
“TROUBLESHOOTING GUIDE” and section “How to avoid
damaging the display or pump switch due to excessive
current”.
“The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Garnet Instruments Ltd. is under license. Other
trademarks and trade names are those of their respective owners.”
To Next Page
Loading...
