26 27
ENEN
Assembly instructions for fitters / Load balancing settings in the web interface Assembly instructions for fitters / Load balancing settings in the web interface
A. Select current or power limitation
B. Set maximum current (A) or power (kWh)
C. In the case of a single-phase charger, if the charger is to be controlled by load
balancing, the phase assignation must be set. Three-phase chargers do not have
phase assignation.
D. Search for other connected wallboxes. These are shown in the list through their
respective serial numbers.
E. Always save settings entered!
A
B
C
E
D
(figure 19)
(figure 20)
To Next Page
Loading...
