1. Power and Factory Reset—Hold 1 second for power ON or OFF. Press and hold 5 seconds
to restore Factory Settings. Tap to exit MENU settings.
2. VOLUME Plus/Minus buttons—Use to increase / decrease detector volume.
3. SENSITIVITY Plus/Minus buttons—Use to increase / decrease Sensitivity setting. These
buttons are also used while adjusting MENU settings.
4. MENU/Iron Check— Repeatedly press to scroll through Menu items, then use the Plus
(+) or Minus (-) buttons above MENU to change setting. Press and hold button to use Iron
Check function.
5. THRESHOLD Plus/Minus—Use to adjust the background audio hum that is added to
target response.
6. Ground Balance—Hold down while bouncing coil above ground until ground response
disappears or becomes as small as possible.
1
2
3
4
5 6 7 8 9
10
1112
1314
15
1. Signal Strength Indicator—indicates both signal strength and polarity.
2. Iron Check—Indicates that Axiom’s Iron Check feature is in use.
3. Mode—Select from Fine, Normal, Large or Salt.
4. Frequency Scan—To overcome EMI, highlight FREQ SCAN on Menu, and press Plus (+) Menu
button to begin the scan. Takes approximately 45 seconds.
5. Tone—Scroll through 00 to 99 to select your preferred audio tone.
6. Audio Type—Select 00 for PWM audio or 01 for VCO audio..
7. Sensitivity—Indicates current Sensitivity setting.
8. Battery Level—Shows status of battery life (25% per segment).
9. Speed—Select Slow, Medium or Fast detection speed.
10. Ground Track—Select O, Slow, Medium or Fast continuous ground tracking speeds.
11. Backlight—Indicates LCD Backlight is on.
12. Wireless headphones—Press Plus (+) Menu button to pair to headphones or Minus (-) to
unpair. Icon ashes while attempting to pair; is solid when unit is paired with headphones.
13. Gnd Balance Arrows—Indicates trending direction of ground balance when Gnd Track is on.
14. Gnd Balance Indicator—Displays while performing ground balance.
15. Ground Balance Values—are shown by the upper and lower 2-digit numbers.
1
2
3
4 5
6
CONTROLS LCD/DISPLAY ELEMENTS
FACTORY DEFAULT SETTINGS
Sensitivity: 6
Volume: 24
Threshold: 15
Mode: Fine
Frequency: 50
Tone: 50
Audio: 01(VCO)
Ground Balance: 49/49
Wireless: O
Backlight: O
Speed: Medium
Ground Track: O
To Previous Page
Loading...
Need help?
General
