26
Chapter 2: Setting Up Your Player
www.gateway.com
6 Enter the name of the network by pressing the remote control’s number
buttons according to the following table. Press to set the next character,
and press
CLEAR to erase a character.
7 Highlight OK, then press ENTER. “Successfully created P2P network”
appears.
8 Press ENTER.
9 On your computer, click Start, Control Panel, then click Network Connections.
10 Right-click Wireless Network Connection, then click View Available Wireless
Networks
.
11 Click the P2P network name you just created on the player, then click
Connect.
If you want to change the player name (as it appears to other players), see
“Changing the player name” on page 28.
12 On the player, highlight OK, then press ENTER on the remote control.
Network setup is complete.
13 Press SETUP or RETURN to close the Setup menu.
14 Go to “Customizing” on page 35 for instructions on customizing your
player’s other settings.
Press: For:
11
2 2, A, B, C
33, D, E, F
44, G, H, I
55, J, K, L
66, M, N, O
7 7, P, Q, R, S
88, T, U, V
9 9, W, X, Y, Z
00
To Next Page
Loading...