Gateway ADC-220 - Defining the Speaker Set

51
Setting up analog audio
www.gateway.com
Defining the speaker set
Use this setting to identify the type of speakers in your audio setup.
To define your speaker setup:
1 On the player’s remote control, press STOP, then press SETUP. The main
Setup menu opens.
2 Use your remote control’s arrow buttons to highlight Analog, then press
ENTER. The Analog audio setup menu opens.
3 Highlight Speaker Set, then press ENTER. The active speakers are listed.
4 Highlight each of the following speakers, then press the buttons to
turn them on or off:
■ Subwoofer
Turns subwoofer output on or off.
■ Surround
Turns left/right surround speaker output on or off.
■ Center
Turns center speaker output on or off.
5 Highlight Ctr Spkr Size, then press the buttons to select Large or Small
to indicate the relative size of the center speaker.
6 Highlight OK, then press ENTER.