Gateway ADC-220 - Changing the Player Name

28
Chapter 2: Setting Up Your Player
www.gateway.com
■ Auto IP — Lets the player obtain an IP address for itself.
■ Static (Manual) — Lets you set the IP address and Subnet Mask.
5 Highlight OK, then press ENTER.
6 Press SETUP or RETURN to close the Setup menu.
Changing the player name
To change the name of the player on the network:
1 On the player’s remote control, press STOP, then press SETUP.
2 Highlight Network, then press ENTER.
3 Highlight Player Name, then use the following buttons to name the player:
■ — Move the text insertion point left and right.
■ 0-9 buttons — Press repeatedly to select the desired character, then
press the button to save the character and move to the next
character.
■ CLEAR — Press to erase a character.
4 Highlight OK, then press ENTER.
5 Press SETUP or RETURN to close the Setup menu.
Important Static IP addresses are numeric addresses that you assign
to uniquely identify your network devices. Only
experienced network users should manually set the
IP address.
If you select Static (Manual), press the button to select
“Set,” then manually enter the IP address and Subnet
Mask with the 0 through 9 buttons. Highlight OK, then
press ENTER to save and exit.