43
Using the universal remote control
www.gateway.com
4 Aim the remote control at the remote sensor of the component that you
want to operate and press the button that corresponds to the function you
want to perform.
Programming the remote control
This remote control can control up to 8 different components.
Before operating audio and video components, other than this receiver, use this
remote control to enter the setup code for each component.
By factory default, 000 is stored in the memory for the CD, DVD, and AUX
device buttons. You do not need to enter a code unless the default code of 000
does not work.
60
o
7m
To Next Page
Loading...
Need help?
General