58
Chapter 3: Using the Receiver
www.gateway.com
Auto tuning
To automatically tune the tuner:
1 If you are using the buttons on the receiver, repeatedly press the TUNE
MODE
button on the receiver to select Tuning mode. The PRESET light turns
off.
- OR -
If you are using your remote control, go to the next step.
2 Press the up and down TUNING/PRESET buttons on the receiver or the
–and+
TUNE buttons on the remote control for more than 0.5 seconds.
The tuner searches until a station of sufficient strength is found.
Weak stations are skipped during auto tuning. To tune in a weak station, use
manual tuning.
Memorizing radio stations
You can store up to 30 radio stations in memory.
To memorize radio stations:
1 Tune in a station using manual or auto tuning.
2 Press the MEMORY button on the receiver. The MEM light flickers for
5 seconds.
3 Press the up and down TUNING/PRESET buttons on the receiver or the
–and+
PRESET buttons on the remote control to select the desired preset
number (1~30) you want, then press the
MEMORY button on the receiver.
You can erase a stored frequency by storing another frequency in its place.
To Next Page
Loading...