59
Analog Audio/Video recording
www.gateway.com
Tuning to preset stations
To tune to preset stations:
1 If you are using the buttons on the receiver, repeatedly press the TUNE
MODE
button on the receiver to select Preset mode. The PRESET light turns
on.
- OR -
If you are using your remote control, go to the next step.
2 Press the up and down TUNING/PRESET buttons on the receiver or the
–and+
PRESET buttons on the remote control to select the desired preset
number (1~30).
You can scan all of the preset stations in sequence by pressing the
P. SCAN
button on your remote control. The receiver pauses at each preset station for
5 seconds. When the station you want is tuned, press the button again to stop
scanning.
Analog Audio/Video recording
■ The analog signals (except front L/R channel) from the 7 CH DIRECT
inputs and the digital signals from the coaxial or optical digital inputs
cannot be recorded.
■ The volume and tone (bass and treble) settings have no effect on the
recording signals.
To record with TAPE:
1 Press the INPUT SELECTOR button on the receiver or the direct input
selector button on the remote control to select the input for your recording
source. You cannot select
TAPE.
2 Start recording on the connected TAPE component.
3 Start playing on the selected input (recording source).
To Next Page
Loading...