26
CORRECT POSITION IN THE VEHICLE GROUP 2/3
(15 – 36 KG)
After changing the car seat to a group 2/3 seat it will be
used without ISOFIX and without Top Tether. As well in
this configuration the car seat ideally should be installed
on the rear bench but in exceptional cases, the car seat
may also be used on the front passenger seat. Please
note the following in this case:
• In cars with airbags, you should push the passenger
seat back as far as possible. When doing so, however,
ensure that the upper belt point of the safety belt is
behind the belt feed point of the car seat.
• Always comply with the recommendations of the
vehicle manufacturer.
!
WARNING! The car seat is not suitable for use
with a two-point or lap belt. If the seat is secured
using a two-point belt, an accident may result in
severe or even fatal injuries to the child.
!
WARNING! The diagonal belt must run back at a
recline and must never run forward to the upper
belt point in your vehicle. If it is not possible to ad-
just the seat in this way, e.g. by pushing the car
seat forward or using it on another seat, this car
seat is not suitable for your vehicle. Contact the
car seat manufacturer if in doubt.
To Next Page
