58
STRAPPING WITH VEHICLE BELT
NOTE! Before using the car seat thick clothing should
be removed. It is like likely to cause a loose harness.
Place your child in the car seat and adjust the height of
the headrest if necessary. Pull the three-point belt right
out and feed it along to the vehicle belt buckle (32) in
front of your child.
!
WARNING! Never twist the belt.
Insert the buckle tongue into the vehicle belt buckle.
It must lock into place with an audible “CLICK”. Next,
place the lap belt (33) in the lower belt guides (34) of
the car seat. Now pull the diagonal belt (35) firmly to
tighten the lap belt. The tighter the belt sits, the bet-
ter it provides protection from injury. On the side of the
vehicle belt buckle, the diagonal belt (35) and the lap
belt (33) must be inserted together into the lower belt
guide (34).
!
WARNING! The vehicle belt buckle must never
cross the belt guide. If the belt system is too long,
the car seat is not suitable for use in this position
in the vehicle. In case of doubt, please consult the
manufacturer.
34
32
35
33
To Next Page
