Concord
12
• Your touchpads display, “ALARM,” and “POLICE,” “AUXILIARY,” or “FIRE.”
• Your touchpads display, “PRESS STATUS” or a blinking .
If an alarm or system trouble condition has occurred, it is displayed on a touchpad the first time
you perform a Short or Full Status check. Performing a system status check a second time dis-
plays the system status including any trouble conditions.
If any alarm or system trouble is active, it continues to show up in every status check until the
system is disarmed.
Short System Status
A Short Status indicates the current arming level, sensor status (whether open or bypassed), low
battery, supervisory, auxiliary phone, AC power or backup battery failures.
¾
To get a Short System Status:
1. Press *. (* is labeled Status.)
The system sounds beeps according to the current arming level (one for Level 1, two for Level 2,
three for Level 3). Touchpads display and optional voice modules announce the status informa-
tion, for example, “SYSTEM IS OK,” or “SENSOR 02 OPEN.”
Full System Status
A Full Status combines the Short Status information with added details about specific system
features.
¾
To get a Full System Status:
1. Press * + *.
Interior sirens sound beeps according to the current arming level. Touchpads display and optional
voice modules announce the status information, for example, “SYSTEM IS OK,” “SENSOR 03
BYPASSED,” “SYSTEM BATTERY IS OK,” “AC POWER IS OK.” If the optional Energy
Saver module is installed the system will display/announce its status (on/off) and the current tem-
perature (if on).
Panic Alarms Panic alarms are easily activated from any touchpad to quickly alert the central monitoring sta-
tion to a Fire, Police, or Auxiliary emergency. A panic alarm can be sent at any time, regardless
of the current arming level:
1—OFF, 2—STAY, or 3—AWAY.
This system is designed to inform a central monitoring station of the nature of the emergency so
the correct personnel can be dispatched immediately.
Each type of panic alarm sounds and reacts differently when activated.
Fire Panic Alarm
The Fire panic alarm sounds from all interior and exterior sirens. On monitored systems, the cen-
tral monitoring station responds by calling the fire department.
¾
To activate a Fire panic alarm from a touchpad:
1. Press and hold both Fire button(s) for 2 seconds.
Lighting During a Fire Panic Alarm
If your system is equipped with system lighting, all system lights will turn on and remain on dur-
ing a Fire panic alarm.
Type of Alarm Alarm Sound
Fire Repeating series of three beeps
Police Continuous tone
Auxiliary Rapid beeps
To Next Page
Loading...
