Concord
54
2. Press B until the touchpad displays “USER CODES,” then press #.
3. The touchpad displays “REGULAR USER CODES” or “REG CODES.” Press
B until the
display reads “SYSTEM MASTER CODE” or “SYS MASTER,” then press
#.
4. Replace the existing code with the new 4 digit System Master Code then press
#.
5. Press
* + 00 + # to exit the programming menus.
Using Programming Shortcuts
A programming shortcut is a number that “jumps” you to a particular spot in the programming
menus.
A series of shortcut numbers takes you directly to the feature or code you want to change.
1. Enter User Programming.
Local Phone # + 9 + CODE
Remote Phone Access Dial the phone number + # + CODE + # + 9 + CODE
Touchpad 9 + CODE
2. Enter a programming command sequence.
Time * + 020 + TTTT + #
Date * + 021 + DDMMYY + #
Regular User Codes User 00: * + 0300000 + NNNN + #
User 01: * + 0300010 + NNNN + #
User 02: * + 0300020 + NNNN + #
(Continues through User 229)
User 229: * + 0302290 + NNNN + #
If using alphanumeric or fixed display touchpads, use A and B to scroll
through the code attributes and change them as required.
Partition Master Codes Partition 1:* + 0310 + NNNN + #
Partition 2:* + 0311 + NNNN + #
System Master Code * + 0320 + NNNN + #
Direct Bypassing Attribute * + 030NNN1 + 1(off) or 2(on) + # (nnn = user no.)
Remote Access Attribute * + 030NNN2 + 1(off) or 2(on) + # (nnn = user no.)
Partition Jump Attribute * + 030NNN3 + 1(off) or 2(on) + # (nnn = user no.)
System Test Attribute * + 030NNN4 + 1(off) or 2(on) + # (nnn = user no.)
Latchkey Report Attribute * + 030NNN5 + 1(off) or 2(on) + # (nnn = user no.)
Downloading * + 040 + 1(off) or 2(on) + #
Silent Arming * + 041+ 1(off) or 2(on) + #
Touchpad Brightness * + 042 + 0 through 3 + #
Volume * + 043 + 0 through 7 + #
Voice Chime * + 044 + 1(off) or 2(on) + #
Chime on Close * + 045 + 1(off) or 2(on) + #
To Next Page
Loading...
