Concord
38
The table on the next page lists the causes of trouble beeps, the visual display you can expect to
see, and possible solutions for the trouble condition.
Silencing Trouble Beeps
If possible, correct the situation which is causing the trouble beeps. If this is not possible, call for
service. If the problem is not corrected, trouble beeps and messages start again 4 or 10 hours
later.
Your security system also has a feature that will prevent trouble beeps from starting during nor-
mal sleeping hours. This “sleep time” period is normally set from 10 pm to 8 am. Contact your
installer if you wish to verify or change this setting.
¾
To silence trouble beeps:
1. Perform a system status check by pressing * on a touchpad,
2. Change the arming level.
The table on the next page describes the conditions under which trouble beeps occur and when
they begin. (These sounds are heard from interior sirens and touchpads if available.)
Common Questions and Answers
Q.I can’t arm my system.
A.Try the following:
• If arming to Level 2—STAY or Level 3—AWAY, make sure all monitored perimeter doors
and windows are closed.
•Press
* for a system status and for clues to the problem.
• Call the installer.
Q.I cannot bypass a sensor: my alphanumeric touchpad displays “INVALID” and my fixed dis-
play touchpad sounds a single, long beep.
A.Possible explanations include:
• The sensor you’re trying to bypass may not be active in the current arming level. For exam-
ple, an interior motion detector will not be active in Level 2—STAY.
• You may be trying to bypass a 24-hour sensor that cannot be bypassed, such as a smoke
detector.
• Your access code has not been assigned the direct bypassing attribute. See “Assigning the
Direct Bypassing Attribute”.
Q.I can’t arm my system to Level 3—AWAY.
A.If a delay door is open while you’re trying to arm the system to Level 3, the system will arm to
Level 2 instead. Close the delay door, arm the system to Level 3, then exit through a delay door.
Phone Issues
Q.How do I disable my system long enough to retrieve messages from work or to do banking over
the phone?
A.Solutions include:
• Disengage the security system from local phone control by entering
# + 7 + 3. The system
responds by returning a dial tone.
• Pick up the phone receiver and wait 5 seconds before dialing any numbers. After the 5 second
period, the system disables local phone control and ignores phone commands.
Siren Issues
Q.When testing my wireless siren, unplugging it does not cause any test results.
A.The test procedure described in “Testing the System” applies only if the siren is supervised. If
the system does not acknowledge the sensor test with two beeps, or the alphanumeric touchpad
does not display “SENSOR nn OK,” your wireless siren may be unsupervised. Check the User
Sheets in Appendix A or ask your installer.
To Next Page
Loading...
