Concord 19
Figure 7.Energy Saver Setpoints
¾ To set the Energy Saver temperature range from a touchpad:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
2. Press
070.
3. Enter the lowest allowable temperature (45–89°F) before the furnace turns on, and press
#.
4. Press
B. Enter the highest allowable temperature (46–90°F) before the air conditioner turns
on, then press
#.
5. Press
* + 00 + # to exit the programming menus.
Note
Disarming the system will
turn the Energy Saver off.
To override your normal heating or air conditioning settings, turn the Energy Saver feature on.
When you are ready to return to your normal temperature control settings, turn Energy Saver off.
¾
To turn Energy Saver on/off from any touchpad:
1. Press 7 + 2. Alphanumeric touchpads display, “ENERGY SAVER IS ON,” for example.
Notification by
Pager
Your system can notify up to five different pager phone numbers to report system events. The
installer can program any pager to receive pages for one or more of the following groups
Pager Messages
When an event is reported on a numeric pager, the following information is included:
H i g h
S e t p o i n t
9 0 °
L o w
e t p o i n t
4 5 °
I f r o o m t e m p e r a t u r e
r e a c h e s l o w s e t p o i n t ,
f u r n a c e t u r n s o n .
I f r o o m t e m p e r a t u r e
r e a c h e s h i g h s e t p o i n t ,
a i r c o n d i t i o n e r t u r n s o n
High Level Reports Low Level Reports
Sensor Alarms Freeze Alarms Bypass Sensors AC Power Failure
Tamper Freeze Troubles Low Battery CPU Low Battery
Restorals No Activity Alarm Supervisory Auto Phone Test
Phone Tests Fire Panic Trouble CPU Back in Service
Receiver Failure Police Panic Phone Test Phone Failure
Receiver Jam Auxiliary Panic Event Buffer Full Touchpad Low Battery
Touchpad Tamper
Bus Failures
• Opening and Closing Reports
• Latchkey Reports
• Notify by Exception Reports
To Next Page
Loading...
