Concord
14
Access Code Integrity
To preserve the integrity of your system, keep access codes confidential and delete extra codes as
soon as they are no longer needed.
We recommend that you avoid using obvious code patterns such as
1234, 1111, 2222, etc.
System Master Code Privileges
Using the System Master code to enter User Programming allows you to:
• Change the System Master code.
• Change or delete the Partition Master code in the current partition.
• Change or delete Regular User codes in the current partition.
The default System Master code is
1234. It is important that you change this default and write
the new code on the User Sheets in Appendix A.
Partition Master Code Privileges
Using the Partition Master code to enter User Programming allows you to:
• Change the Partition Master code in the current partition.
• Change or delete the Regular User codes in the current partition.
There is not a default Partition Master code. Write partition master codes on the User Sheets in
Appendix A.
Regular User Code Privileges
You cannot enter User Programming with a Regular User code.
The Touchpad Tamper Feature
The installer can program your system to send a Police alarm in the case of possible touchpad
tampering.
If more than 40 keys are pressed when the system asks for a code, and those keystrokes are not
part of a valid access code, a siren will sound. Talk to your installer or see Appendix A “Touch-
pad Information” on page 42 to see if this feature is enabled.
Changing or Erasing User Codes
A Touchtone phone can be used to change or erase user codes, but alphanumeric or fixed display
touchpads work much better because of their extensive feedback. See Appendix C for phone pro-
gramming instructions.
Changing a User Code
Note
To change System and Par-
tition Master codes please
see Appendix C: “Using Pro-
gramming Menus”.
¾ To change or assign a user code:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
2. Press
030 nnn 0 where nnn is the user 000 through 229.
3. Enter the desired 4-digit code, then #.
4. Press
* + 00 + # to exit the programming menus.
Note
The system will not accept
the same code for two differ-
ent users.
Erasing a User Code
When a code is deleted from the system, that code no longer acts as a key for operating the sys-
tem in any manner.
¾
To erase a user code:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
2. Press
030 nnn 0 where nnn is user 000 through 229.
3. Enter the System or Partition Master
CODE, then #.
4. Press
* + 00 + # to exit the programming menus.
To Next Page
Loading...
