Simon Security System
8
EMERGENCY
Press FIRE, POLICE, or AUX for 2 seconds (or press twice quickly) to call the central
monitoring station and notify them of a non-medical call for help.
How Your
System
Communicates
to You
Your system responds to you through the use of panel voice messages, status beeps,
alarms, panel indicator lights, and to a numeric pager or remote phone if programmed.
Panel Voice Messages
When you press the buttons on the panel or the touchpads, the panel responds with
voice messages. Panel voice can be enabled or disabled (see “Options”).
Note
The panel will not give voice
messages during an AVM
session. Talk to your security
system dealer to see if your
panel has the AVM option.
These messages may respond with system information or prompt you to take further
action. For example, if you want to disarm the system and you press the DISARM but-
ton, the panel responds by announcing, “Please enter your access code.”
If you press a button and the feature has not been programmed, the panel voice will
respond with “Function not available.” An example of this would be pressing Lights
Sensor (activated) button when you have no sensor activated lights in your system.
Status Beeps
Note
You may receive a different
number of status beeps if
buttons are pressed quickly
Status beeps are used to indicate key presses, status, and problems with the system.
They can be enabled or disabled (see “Options”). The following table describes status
beep activity.
.
E M E R G E N C Y
A U X
P O L I C EF I R E
Status Beeps
Activity Beep Response
ARM Doors & Windows Exit delay and Entry delay beeps sound 2 times
every 5 seconds and 2 times per second during
the last 10 seconds (if Silent Exit is used, the Exit
delay beeps will only sound twice when you arm
and twice when the Exit delay expires)
ARM Motion Sensors Exit delay and Entry delay beeps sound 3 times
every 5 seconds and 3 times per second during
the last 10 seconds (if Silent Exit is used, the Exit
delay beeps will only sound 3 times when you arm
and 3 times when the Exit delay expires)
ARM Doors/Windows &
Motion Sensors
Exit delay and Entry delay beeps sound 4 times
every 5 seconds and 4 times per second during
the last 10 seconds (if Silent Exit is used, the Exit
delay beeps will only sound 4 times when you arm
and 4 times when the Exit delay expires)
DISARM 1 beep
CHIME DOORS 2 beeps (feature must be programmed by installer)
CHIME SPECIAL MOTION 3 beeps (feature must be programmed by installer)
Trouble Beeps 6 beeps every minute. Press the SYSTEM STA-
TUS button to stop beeps for 4 hours
No Activity Beeps 20 beeps every minute for 5 minutes (feature must
be programmed by the installer)
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
