Simon Security System 25
Testing As an added safeguard, there are system tests you should do yourself on a regular
basis. It is recommended that you test your system weekly.
Testing Sensors
You can test sensors one at a time to make sure they are sending strong signals to the
panel. You should test the security system at least once a week.
¾
To perform the sensor test:
1. Open the panel Cover.
2. Enter the master access code.
3. Press the Test button once. The panel will announce Sensor Test.
4. Press the DONE button.
Note
The RF Electronic Thermo-
stat and DTIM are automati-
cally tested when a sensor
test begins. The panel will
announce, Sensor XXX acti-
vated, status is one, if the
thermostat and DTIM are
OK. There can be delays
when the thermostat and
DTIM are automatically
tested.
The panel will voice prompt you with a list of your programmed sensors that you need
to test. The panel will start with sensor 1 and announce Test sensor 1, sensor name.
When you trip a sensor and it communicates successfully it will be removed from the
list. You may trip the sensors in any order.
After all sensors have been successfully tested, the panel will announce Sensor test
complete, press DONE. Press DONE. The panel will announce Sensor test ok.
If any of the sensors did not test successfully and you want to terminate the test, press
DONE or Cancel. The panel will announce Sensor test canceled or failure. If a sensor
test fails, call your security dealer.
Use the following table to trip devices:
Device Do This
Door/Window Sensor Open the secured door or window.
Freeze Sensor Apply ice to the sensor. Do not allow the sensor to get
wet.
Water Sensor Press a wet rag or wet finger over both of the round,
gold-plated terminals on the underside of the sensor.
Carbon Monoxide Sensor Unplug the CO Alarm. Plug it back in, then press the
TEST/RESET button until the unit beeps 8 times.
Glass Guard Sensor Tap the glass 3 or 4 inches (8 cm) from the sensor.
Motion Sensor Avoid the Motion Sensor’s view for 5 minutes, then
enter its view.
Rate-of-Rise Heat Detector Rub your hands together until warm, then place one
hand on the detector for 30 seconds.
Shock Sensor Tap the glass twice, away from the sensor. Wait at least
30 seconds before testing again.
Smoke Sensor Press and hold the test button until the system sounds
transmission beeps.
Wireless Panic Button Press and hold the appropriate panic button(s) for 3
seconds.
Keychain Touchpad Press and hold LOCK and UNLOCK simultaneously for
3 seconds.
Remote Handheld Touch-
pad
Press and hold the 2 EMERGENCY buttons simulta-
neously for 3 seconds.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
