Simon Security System 13
Note
For any keypress on the
Keychain Touchpad, hold
the button until the indicator
light blinks.
LOCK Press once to arm doors and windows.
LOCK Press twice to arm doors, windows, and Motion Sensors.
LOCK Press 3 times to arm doors, windows, Motion Sensors, and to acti-
vate the Latchkey option.
LOCK and UNLOCK
Press both buttons simultaneously for 3 seconds to send a panic (intru-
sion, silent, or non-medical emergency) alarm to the central monitoring
station. Check with the installer to find out how the keychain touchpad
panic buttons will operate
Note
Panic alarms need to be
silenced from the panel, a
remote handheld touchpad
or another keychain touch-
pad. They cannot be
silenced from the same key-
chain that activated the
alarm.
UNLOCK Press to disarm your security system.
STAR Can be programmed to control a device connected to a Universal
Module.
LIGHT Can be programmed to control a device connected to a Lamp Mod-
ule. One press all lights on Lamp Modules turn on. Press again all lights turn
off.
Using a
Computer
With a Ethernet Interface module installed in your panel, you can control your system
via the premisesconnect.com website.
Premisesconnect.com can be used by:
• Installers - to aid in installation and maintenance of security systems.
• Dealers - to simplify customer and account management.
• First Responders - to identify where and how to respond.
• Customers - to control their security system.
For more information on controlling your system via a computer, visit premisescon-
nect.com.
RF Thermostat
Operation
These guidelines must be followed for RF Thermostat operation:
• The panel needs to be armed to Doors & Windows and Motion Sensors to enter
Energy Saving Mode.
• If there are no Motion Sensors in the system, the Motion Sensors button must still
be pressed.
• Both Option 81 and 82 can be turned on at the same time.
• Thermostat has to be in Auto Mode for Options 81 and 82 to work correctly.
• When the panel is disarmed the thermostat returns to normal operating mode.
Programming
Your System
The programming decals are visible when you open the panel cover (see below).
These decals are designed to make system programming easier for you. Always begin
by entering your master access code. Then, choose an operation from the START
MENU. Follow the prompts and flow arrows to complete the desired task. Notice the
button flow diagrams following the Instruction Summary.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
