GE 27909 - Registration; Egister


Registration
NOTE: The following procedures can ONLY be done with 27909 or
27911 Accessory Handsets.
A cordless handset will not operate until it is registered to the base. During the
registration process, keep the handset near the base. Up to 4 cordless handsets can
be registered to one base.
NOTE: If a handset is not registered; Not Register ashes on the
display and if the TALK button on the handset is pressed, it will
display Unavailable.
1. Make sure your phone is OFF (not in talk mode).
. Press the
menu button to go to the main menu and use cid/vol (3or4) button to
scroll to Registration.
. Press
menu button to conrm and you may program the following items: Register
and Remove handset.
Register
From the Registration Menu:
1. Press the
cid/vol (3or4) button to scroll to the Register sub-menu.
. Press
menu button to enter the menu.
. Press and hold the
page button on base for 5 seconds.
4. The charge/in use indicator will ash slowly for  minutes which indicates the
base is in registration mode.
5. If the registration is successful, the handset screen displays
Successful and emits
a conrmation tone for  seconds.
6. If the registration is failed (i.e. timeout), the handset screen displays
“No base”
and emits an error tone.