Why won't my GE Ranges oven self-clean?
If your GE Ranges oven won't self-clean, the oven temperature may be too high. Allow the oven to cool down before resetting the controls. Also, make sure the oven controls are set properly. See the Care and Cleaning – Interior Surfaces section.
Why is there no conditioned water after regeneration in my GE Water System?
If your GE Water System is not providing conditioned water after regeneration, it could be due to a lack of salt in the brine tank, so add salt to the brine tank. Another cause could be a plugged injector, so clean the injector and screen. The air check valve might also be closing prematurely, so put the control momentarily into brine/slow rinse.
Why isn't my GE 400 Ranges oven clean after self-clean?
If your GE Ranges oven is not clean after a self-clean cycle, it may be because the oven was heavily soiled. Clean up heavy spillovers before starting the cleaning cycle. For heavily soiled ovens, you may need to run the self-clean cycle again or for a longer period. Also, ensure that the oven controls are properly set; refer to the Care and Cleaning – Interior Surfaces section.
Why is my GE Water System using more or less salt than the regenerant setting?
If your GE Water System is using more or less salt than the regenerant setting, it could be due to foreign matter in the controller causing incorrect flow rates. Remove the brine control and flush out any foreign matter. Manually position the control to brine/slow rinse to clean the controller, and then position the control to "purge” to remove brine from the tank.
What to do if my GE Water System runs out of soft water between regenerations?
If your GE Water System is running out of soft water between regenerations, ensure that you repeat regeneration, making certain that correct salt dosage is used. Also check if the salt setting is correct using the salt setting chart. Make sure your hardness or capacity settings are correct by checking the Programming section. It's also possible that the water hardness has increased, so set the hardness to the new value by checking the Programming section. Finally, check for restricted meter turbine rotation due to foreign material in meter by removing the meter housing, freeing up the turbine and flushing with clean water. The turbine should spin freely; if not, replace the meter.
Why does my GE Ranges oven glass look tinted?
If the inner oven glass of your GE Ranges appears tinted or has a rainbow color, it is normal. The glass is coated with a heat barrier to reflect heat back into the oven, preventing heat loss and keeping the outer door cool.
Why is my GE 400 smoking during self-clean?
If your GE Ranges is producing excessive smoke during the self-clean cycle, there's likely excessive soil or grease in the oven cavity. Press the Cancel pad, open the windows to ventilate the room, and wait until the light goes off. Wipe up the excess soil or grease, then reset the self-clean cycle.
Why aren't my GE 400 Ranges surface units working?
If your GE Ranges surface units aren't working, a fuse in your home may be blown, or the circuit breaker may have tripped. Replace the fuse or reset the circuit breaker. Also, verify the correct control is set for the surface unit you are using.
Why does my GE 400 beep and flash?
If your GE Ranges control beeps or flashes, it means you likely forgot to enter a bake temperature or cleaning time. Refer to the Oven Controls section for instructions on setting the oven.
Why is the display flashing on my GE 400?
If your GE Ranges display is flashing, it likely indicates a power outage or surge. Reset the clock. If the oven was in use, press the Cancel pad, set the clock, and reset any cooking functions.
General| Self-Cleaning | Yes |
|---|---|
| Number of Burners | 4 |
| Width | 30 inches |
| Oven Type | Conventional |
| Cooktop Material | Glass |
| Color | Black |
To Next Page
