Why is the display flashing on my GE 400?
If your GE Ranges display is flashing, it likely indicates a power outage or surge. Reset the clock. If the oven was in use, press the Cancel pad, set the clock, and reset any cooking functions.
Why does my GE 400 beep and flash?
If your GE Ranges control beeps or flashes, it means you likely forgot to enter a bake temperature or cleaning time. Refer to the Oven Controls section for instructions on setting the oven.
Why aren't my GE 400 Ranges surface units working?
If your GE Ranges surface units aren't working, a fuse in your home may be blown, or the circuit breaker may have tripped. Replace the fuse or reset the circuit breaker. Also, verify the correct control is set for the surface unit you are using.
Why is my GE 400 smoking during self-clean?
If your GE Ranges is producing excessive smoke during the self-clean cycle, there's likely excessive soil or grease in the oven cavity. Press the Cancel pad, open the windows to ventilate the room, and wait until the light goes off. Wipe up the excess soil or grease, then reset the self-clean cycle.
Why does my GE 400 oven take so long to preheat?
If your GE Ranges oven takes longer to preheat, it might be due to cookware or food inside; remove these to reduce preheat time. The number of racks also affects preheating time, so remove extra racks. Using a flat rack instead of an extension rack can help. Also, different cooking modes require different preheating times.
Why are my GE Ranges oven racks hard to slide?
If your GE Ranges oven racks are difficult to slide, and they are the shiny, silver-colored type, it may be because they were cleaned during a self-clean cycle. Apply a small amount of vegetable oil to a paper towel and wipe the edges of the racks. Do not use cooking sprays or peanut oil. Alternatively, dirty cabinetry and/or flat racks may need cleaning and lubrication. See the Care and Cleaning – Interior Surfaces section. For extension racks, use the lubrication method described in the Care and Cleaning – Interior Surfaces section. For self-clean, enameled racks refer to the Care and Cleaning – Interior Surfaces section.
What to do if the GE 400 oven door won't open?
If your GE Ranges oven door will not open, it may be locked because the internal temperature hasn't dropped below the unlocking point. Press the Cancel pad and allow the oven to cool down.
What to do if the GE 400 Ranges display is blank and the oven doesn't work?
If the display is blank and the oven is unresponsive, check your home's fuse box or circuit breaker. A blown fuse or tripped breaker could be the cause. Replace the fuse or reset the circuit breaker. Also, ensure the range is fully plugged into a properly grounded electrical outlet.
Why won't my GE Ranges oven door open after self-clean?
If your GE Ranges oven door will not open after a self-clean cycle, it's likely that the oven is still too hot. Check if the control display indicates that the unit is still locked. Allow the oven to cool down below the unlocking temperature.
Why won't my GE Ranges oven self-clean?
If your GE Ranges oven won't self-clean, the oven temperature may be too high. Allow the oven to cool down before resetting the controls. Also, make sure the oven controls are set properly. See the Care and Cleaning – Interior Surfaces section.
General| Self-Cleaning | Yes |
|---|---|
| Number of Burners | 4 |
| Width | 30 inches |
| Oven Type | Conventional |
| Cooktop Material | Glass |
| Color | Black |
To Next Page
