Programming the Panel 32
Reporting Menu
The REPORTING menu lets you set up which system events (global or partition) are reported to the
central monitoring station. The following describes how to program the reporting settings that
appear under GLOBAL.
Aux. Panic (0401)
Touchpad Options-Partition 1 (Default=on)
This setting determines whether touchpad auxiliary panic buttons are enabled
(on) or disabled (off).
¾
To change the Auxiliary Panic setting:
1. With the display showing
AUXILIARY PANIC
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press ƒ and the display shows the new set-
ting.
Police Panic (0402)
Touchpad Options-Partition 1 (Default=on)
This setting determines whether touchpad police panic buttons are enabled
(on) or disabled (off) on.
¾
To change the Police Panic setting:
1. With the display showing
POLICE PANIC OFF/
ON
(current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press
ƒ and the display shows the new set-
ting.
Keychain TP Arm (0403)
Touchpad Options-Partition 1 (Default=off)
This setting determines how the keychain touchpad arms the system. When set
to ON, pressing the
LOCK button arms the system directly to AWAY with no
Entry and Exit Delay. When set to OFF, pressing the
LOCK button increments
the arming level from OFF to STAY and from STAY to AWAY.
¾ To change the Keychain Touchpad Arm-
ing setting:
1. With the display showing
KEYCHAIN TOUCH-
PAD ARM OFF/ON
(current setting), press 1
(off) or 2 (on). The display flashes the
entered setting.
2. Press
ƒ and the display shows the new set-
ting.
Star Is No Delay (0404)
Touchpad Options-Partition 1 (Default=off)
This setting determines whether the keychain touchpad star button controls an
onboard or SnapCard output (off) or the No Delay feature (on).
¾
To change the Keychain Star Is No Delay
setting:
1. With the display showing
STAR IS NO DELAY
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press ƒ and the display shows the new set-
ting.
24-Hour Tamper (05000)
Reporting-Global (Default=off)
When this feature is turned on, the panel sounds sirens and reports a tamper
alarm when wireless sensor tamper switches are activated (even when the sys-
tem is disarmed).
¾
To turn 24-Hour Tamper off or on:
1. With the display showing
24-HOUR TAMPER
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press ƒ and the display shows the new set-
ting.
To Next Page
Loading...
Need help?
General
