GE 60-806-95R-16Z - Security Concord Express System Control Panel User Manual

Programming the Panel 34
Buffer Full Rpt (05006)
Reporting-Global (Default=off)
When this setting is turned on, the panel sends an “event buffer full” report to
the central monitoring station when the panel event buffer (memory) is nearly
full.
¾
To turn Buffer Full Report off or on:
1.
With the display showing BUFFER FULL RPT
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press
ƒ and the display shows the new set-
ting.
Zone Restorals (05007)
Reporting-Global (Default=off)
When this setting is on, the panel reports a restoral to the central monitoring
station (or pager) when wireless or hardwire zones in alarm are reset or
“restored” before the alarm is canceled.
Note
As with all GE Security panels, hardwire smoke detectors connected to Concord or
SnapCard hardwire zones do not send restorals.
¾ To turn Zone Restoral reporting off or on:
1. With the display showing
ZONE RESTORALS
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press
ƒ and the display shows the new set-
ting.
Two Trip Error (05008)
Reporting-Global (Default=off)
This setting works with the “Alarm Verify” feature. If Alarm Verify is turned
on, then the panel waits for a second sensor trip before sending an alarm (see
“Appendix A: Table A3. Sensor Group Characteristics”).
If Two Trip Error is also on and a second sensor trip does not occur within a 4-
minute time period, then the panel sends an error report to the central monitor-
ing station.
When this feature is turned off, the panel does not send “Two Trip Error”
reports.
Note
For UL Listed systems, Two Trip Error must be turned off.
¾ To turn Two Trip Error off or on:
1. With the display showing
TWO TRIP ERROR
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press
ƒ and the display shows the new set-
ting.
TP Panic RPT FMT (05009)
Reporting-Global (Default=off)
This setting determines how the panel formats touchpad panic alarms reports
to the central station.
When this feature is on, touchpad panic alarms report using the following 3-
digit codes:
Auxiliary—597, Police—598, Fire—599
When turned off, touchpad panic alarms report using a 3-digit code from 500
to 503 with the last digit identifying the touchpad device number.
¾
To turn TP Panic RPT FMT off or on:
1. With the display showing
TP PANIC RPT FMT
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press ƒ and the display shows the new set-
ting.
AC Failure (05010)
Reporting-Global (Default=off)
When this setting is on, the panel reports to the central station if AC power to
the panel is out for 15 continuous minutes.
Note
For UL Listed systems, AC Failure must be turned on.
¾ To turn AC Failure reports off or on:
1. With the display showing
AC FAILURE OFF/
ON
(current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press ƒ and the display shows the new set-
ting.

GE 60-806-95R-16Z - Security Concord Express System Control Panel Specifications

General

Brand	GE
Model	60-806-95R-16Z - Security Concord Express System Control Panel
Category	Security System
Language	English