CHAPTER 3: INTERFACES SOFTWARE INTERFACE
850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL 3–43
3. The EnerVista 8 Series Setup software requests the new firmware file. Locate the
folder that contains the firmware file to load into the 850.
The firmware filename has the following format.
The following screen appears. Select YES to proceed.
4. EnerVista 8 Series Setup software now prepares the 850 to receive the new firmware
file. The 850 front panel momentarily displays “Upload Mode”, indicating that it is in
upload mode.
5. The following screen appears, click YES to proceed with the firmware loading process.
J2 J08 A A
150 . SFD
File type
Board Assembly Rev #
Code Type in Memory Device
PCB Code Number
Product Reference Code (J0=8 Series)
Firmware Rev #
To Next Page
Loading...
