GE 850 - Remote Module I;O (RMIO)

2–10 850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
MECHANICAL INSTALLATION CHAPTER 2: INSTALLATION
Remote Module I/O (RMIO)
If using the Remote RTD module, follow these installation steps.
Figure 2-13: RMIO - DIN rail mounting - Base & Expansion units
Figure 2-14: RMIO - Base Unit screw mounting
SNAP-IN THE DIN CLIPS (QTY: 4)
FOR DIN RAIL MOUNTING
0.30”
(7,6 mm)
1.38”
(35,1 mm)
DIN 3 RAIL
853726A1.CDR
MEETS VIBRATION REQUIREMENT OF
IEC 60255 SEC 21.1, 21.2, & 21.3
2.250”
(57,15 mm)
#6 -32 THREADED HOLE
QTY: 2
4.100”
(104,14 mm)
853727A1.CDR