GE 850 - Results Window

3–62 850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
SOFTWARE INTERFACE CHAPTER 3: INTERFACES
Results Window The following figure shows an example conversion summary results window.
Figure 3-30: Results Window
The results window has the following columns:
• Name: the same tree structure as in the offline window, but with status icons
NOTE
NOTE:
Settings in the results window are linked to setting screens. Click in the results window to
navigate to the corresponding 8 Series settings window.
• Value: the converted value for the 8 Series settings file
• Original Name: setting name of the input file
• Original Value: setting value of the input file
CAUTION:
All other settings available (not shown in the conversion report) in the 8 Series file are
set to default and must be verified before putting the relay into service.
Status Icons
The status icon shows the conversion results:
Manual configuration required
Successful conversion
Value is not supported
Print Report If desired, the conversion summary report can be printed using the File/Print
command in the EnerVista taskbar or it can be printed from the “GUI” print button.
NOTE
NOTE:
Although the report shows successful conversion (green checkbox), the settings must still
be verified before putting the relay in service.