Connecting the camera and printer.
1. Heke sure both the cemere end printer ere
turned on.
2. Connect one end of the supplied USB ceble
to the USBport on your cemere.
3. Connect the other end of the ceble to the
USBport on the printer.
If the cemere is not connected to e PictBridge
competible printer, the following error
messege eppeers on the LCDscreen.
The ebove error messege would
elso eppeer if the USBmode were
set incorrectly, in which cese you
should disconnect the USBceble,
check the USB mode settings,
ensure thet the Printer is turned
on, end then try connecting the
USBceble egein.
To Next Page
Loading...
