AMX−4+ OPERATION
GE MEDICAL SYSTEMS (MODEL 2169360, 2236420 & 2275938 SERIES)
REV 10 om 2166913−100
3−3
3−1 Turning the AMX−4+ On
Steps
Be sure to refer to Maintenance and Service in this manual for important information on
the circuit breaker.
1. Turn the keyswitch to the ON position.
ILLUSTRATION 3−3
KEYSWITCH
Keyswitch in
ON position.
D The unit performs diagnostics (self−tests to make sure everything is working cor-
rectly). This process takes a few seconds.
TESTING COMPLETE
2. When the technique and battery status displays light up, the unit is ready for op-
eration. TESTING COMPLETE will also briefly appear on the message display.
3. If TEST −− XX FAILED is displayed, turn the unit OFF then ON again. If TEST
−− XX FAILED displays again, write down the alphanumeric code (XX represents
the code) and contact your service representative.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).