– 42 –
This feature allows outside air into the room. The
door is secured with two screws from the factory
that must be removed upon installation if the
customer would like to use this feature. The damper
assembly consists of a door, ¿lter, rod and wing
nut. The wing nut can be loosened and the rod may
be slid back which opens the door. It then can be
locked into place by tightening the wing nut.
Damper Door
This feature allows outside air to be “conditioned”
before entering the room.
The module is secured with two screws and tabbed
into a base plate mounted to the base pan. Some
new zoning regulations require that incoming air be
conditioned.
The module is a small dehumidi¿er and will be
replaced as an assembly.
An ON/OFF switch and compressor test switch are
mounted to the front control.
Make-Up Air Module (MUAM)
(Continued next page)
To Next Page
Loading...
Need help?
General
