GE b30 Technical Reference Manual

B30 Patient Monitor
A-4
Document no. 2044677-001
5. Click Open License button, choose the license file you have. The CPU Serial Number and
Software Version will be automatically imported through the license file.
6. Press Emergence button to start software download.
NOTE: When the emergence download for the main software is done successfully,
waiting for 3 to 5 minutes until the B30 monitor restart automatically.
Verification and configuration
1. Perform Factory Reset.
Monitor Setup
Install/Service (16-4-34)
Service (26-23-8)
Set/Test
Factory Reset
After the Factory Reset is completed, the B30 monitor will restart automatically.
2. Set the time and date.
Monitor Setup
Time and Date
3. If necessary, set the monitor’s network communication according to the used network
software.
Monitor Setup
Install/Service (16-4-34)
Service (26-23-8)
Frame
Network
Dri Config
DRI level
Central station software S-CNET01 -> DRI Level = 2001
Central station software S-CNET02 -> DRI Level = 2002
Central station software L-NET03 or L-NET05 -> DRI Level = 2003
NOTE: If the DRI level is changed, the B30 monitor will restart automatically. The
change will take effect only after restart.
4. Verify that the software has been installed correctly.
Monitor Setup
Install/Service (16-4-34)
Service (26-23-8)
SW Version / Unit Id
5. Verify that the active language is installed and activated correctly
Monitor Setup
Install/Service (16-4-34)
Service (26-23-8)
SW Settings
Country Settings

GE b30 Specifications

General

Model	b30
Manufacturer	GE
Coil Voltage	N/A (Solid State Relay)
Coil Power	N/A (Solid State Relay)
Mechanical Life	N/A (Solid State Relay)
Electrical Life	N/A (Solid State Relay)