GE Brivo OEC 865 - Page 124

Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product
Page 6-17
4. Select the “Empty Density...” button and choose the image empty density. The available options are:
• BLACK
• WHITE
5. Select the “Copies...” button and choose the number of copies that will be printed each time a print
command is sent to this printer. The available options are 1 to 10.
6. Select the “Print Priority...” button and choose a print priority. The available options are:
• HIGH
• MEDIUM
• LOW
7. Select the “Destination...” button and chose a print destination. The available options are:
• MAGAZINE
• PROCESSOR
8. Select the “Medium Type....” button and choose a medium type. The available options are:
• PAPER
• CLEAR FILM
• BLUE FILM
• MAMMO CLEAR FILM
• MAMMO BLUE FILM
9. Select “Orientation” button and choose an orientation. The available options are:
• PORTRAIT
• LANDSCAPE
10. Select the “Film Size...” button and choose a film size. The available options are:
• 8IN × 10IN
• 10IN × 12IN
• 10IN × 14IN
• 11IN × 14IN
• 14IN × 14IN
• 14IN × 17IN
• 24CM × 30CM
• 24CM × 24CM
11. Select a film layout for the X-Ray images. You can select up to four layouts for each DICOM printer
device you are configuring.
The film matrix determines the printed layout for the X-Ray images in columns and rows. The matrix
choices are limited to those available from the selected printer. The total number of images printed on one
film sheet is the product of the two numbers.